Advertisement
3-PT Hitch Model Warning
Lamps Installatio
Amber Lamps are assembled to the outer extremity of
machine.
1. With the Warning Lamp Brackets bends inward,
mount a Warning Lamp Bracket to the inside of each
end frame Bracket with 1/4-20 x 1 Bolts and Locknuts.
See Figure 2-11.
2. Secure Lamp Shields onto Warning Lamp Brackets
with 1/4-20 x 1 Bolts and Locknuts.
3. Unscrew Amber Lamp Jam Nut if not already
removed from Lamp Stud so that the Nut and
Washers fall down to the plug. Place an Amber Lamp
inside a Lamp Shield so that the Lamps threaded stud
sits in the radius of the slot and insert the stud into
each Warning Lamp Bracket slot. Secure Amber
Lamps with Jam Nut and Washers.
4. Install the Red Lamps to the inner Light Mount
Brackets by sliding the lamp cord into the slot. Secure
Red Lamps with Jam Nut and Washers.
5. Install the SMV Bracket to the frame bracket with
5/16-18 x 1 Bolts, Flat Washers and Locknuts.
6. Attach SMV Sign to the SMV Bracket with 5/16-18 x 1
Bolts, Flat Washers and Locknuts.
7. Attach the Flasher Control Module to the underside of
the Manual Holder with 1/4-20 x 1-1/2 Bolts, Flat
Washers and Locknuts.
IMPORTANT
Cords are marked Yellow for Left and Green for
Right.
8. Lay out the Lamp Harness and attach the harness to
the Flasher Control Module.
9. Route the left and right 3 plug cord along the frame
and connect to each Red Lamp.
10. Route the remaining left and right 2 plug cord along
the left and right of the frame and under the Seed Box
Supports, connect into each Amber Lamp.
11. Lay out the 7-Pin Harness and attach the harness to
the Light Module.
12. Route the 7-Pin Harness up the 3-PT Hitch.
13. Bundle and secure with tie wraps after Nylon Tubing,
and all Harnesses have been installed.
2-12
TABLE OF CONTENTS
n
IMPORTANT
All harnesses must be firmly attached to machine
frame members, or nylon tubing, so they don't sag or
become torn loose by field debris. Use the tie wraps
provided.
Check to be sure the harnesses at center of machine
is slack enough so as not to be stretched or
interfered with while rotating frame from transport to
field working position and vice versa.
NOTE
The 7-Pin harness connects to the tractor socket when in
use. When not in use, it can be stored in the Plug Holder
on the 3-PT Hitch. Allow enough harness length to reach
tractor socket and roll or fold up excess and secure to
hydraulic hoses or 3-PT Hitch.
F-1021-0422
Advertisement
