Advertisement
S-Tine Harrow Installation -
Optional
CAUTION
Do not work on or under this machine unless
securely blocked and supported by a hoist or
tractor or by other sufficient means.
1. Attach the Harrow Mounting Brackets to the Seeder
Frame Tube with 3/4-10 U-Bolts, Flat Washers, and
Locknuts. See Figure 2-33.
2. Slide the S-Tine Harrow Adjuster up into the Harrow
Mounting Bracket. Align the holes and insert Hitch Pin
and secure with Hair Pin Cotter.
3. Insert the 165" Square Tube into the Harrow Adjuster
Cutout. Ensure that the 165" Square Tube is equally
spaced from side to side. Secure with 5/8-11 U-Bolts,
Thick Washers, and Locknuts.
4. Attach the Sidewind Jack to the Harrow Mounting
Brackets with 5/8-11 x 1-3/4 Bolts and Locknuts.
5. Attach the bottom of each Jack to the bottom of the
S-Tine Harrow Adjuster. Cranking the Jack up or
down to align the holes. Secure with a 1/2-13 x 3-3/4
Bolt and Flanged Locknut.
6. Locate and install S-Tines as needed to cover Tractor
Tire Tracks onto the 165" Square Tube with Clamps
7/16-14 Carriage Bolts and Locknuts. Attach Points to
S-Tines with 3/8-16 x 1-3/4 Plow Bolts and Locknuts.
Suggested pattern is to use 1-5/8" Reversible Points
on center S-Tine and 2-1/2" Duckfoot Points on each
side of Wheel Track. If needed, additional S-Tines
and Points can be purchased and installed.
2-36
TABLE OF CONTENTS
F-1021-0422
Advertisement
