Advertisement
Drawbar Installation
WARNING
Do not attempt to lift heavy parts manually. Use a
hoist or a fork lift to move these parts into
position.
1. Center the Drawbar Assembly on Seeder Frame and
attach with 3/4-10 U-Bolts, Flat Washers and
Locknuts. Tighten. See Figure 2-1.
Locknut,1/4-20
Hose Support
Bolt,5/8-11 x 2
Flat Washer,5/8
Locknut,Flange
5/8-11
Drawbar
Assembly
2-2
TABLE OF CONTENTS
Flat Washer,3/4
Locknut,3/4-10
Bolt,5/8-11 x 1-3/4
Flat Washer,5/8
Air Manifold
Assembly
Locknut,Flange
5/8-11
Manual Holder
Bolt,1/4-20 x 1
Flat Washer,1/4
Figure 2-1: Drawbar Installation
2. Install Toolbox to Drawbar cross member with 3/8-16
x 1 Bolts, Flat Washers and Flanged Locknuts.
3. Attach Air Manifold Assembly to the Drawbar cross
member with 5/8-11 x 1-3/4 Bolt, Flat Washer and
Flanged Locknut.
4. Attach the Manual Holder to the Drawbar with 1/4-20
x 1 Bolts, Flat Washers and Locknuts.
5. Install Hose Support to the Drawbar with 5/8-11 x 2
Bolt, Flat Washer and Flanged Locknut.
6. Place Wrenches and Calibration Crank in Toolbox.
U-Bolt,3/4-10
Calibration Crank
Bolt,3/8-16 x 1
Flat Washer,3/8
Toolbox
Locknut,Flange 3/8-16
Assembly
Wrenches
F-1021-0422
Advertisement
