Advertisement
Console w/Clutch Control
Tractor Installation - Optional
1. Mount Angle Bracket onto Tractor where convenient
for the operator. See Figure 2-28.
2. Attach Straight Bracket to Angle Bracket with 1/2-13 x
1-1/2 Bolt and Flanged Ny-Lok Nut.
3. Attach the Clutch and Seed Shaft Sensor Console to
the Straight Bracket with 1/4-20 x 1 Bolt, Flat Washers
and Locknut.
Bolt,1/4-20 X 1
Straight Bracket
Washer,Flat 1/4
Nut,Lock 1/4-20
F-1021-0422
TABLE OF CONTENTS
SSP16 Monitor
Console
Figure 2-28: Clutch and Seed Shaft Sensor Console - Optional
4. Plug Console 3-Pin Power Cord into the Tractor
Convenience Outlet and 9-Pin Cord into the 4ft or 20ft
Extension Harness.
5. Check clutch operation: Clutch will engage when
power is applied. (Clutch will make a clicking sound).
Set seeder on the ground and drive a short distance
while turning switch on and off. The seed shaft will
stop rotating when switch is turned to "NO SEED"
position. See "Seed Rate Adjustment" on page 3-8.
Washer,Flat 1/4
Bolt,1/2-13 X 1-1/2
Nut,Flange
Ny-Lok,1/2-13
Angle Bracket
2-31
Advertisement
