Advertisement
Speed Source Displays
SPEED SETTINGS
SOURCE:
SHAFT SPEED
PULSES PER
4
WHEEL
90
SPEED
CALIBRATION
Figure 4-3: Source: Shaft Sensor Speed Display
SPEED SETTINGS
SOURCE:
RADAR
RADAR PULSES
15815
SPEED
CALIBRATION
Figure 4-4: Source: Radar Speed Display
SPEED SETTINGS
SOURCE:
GPS
Figure 4-5: Source: GPS Receiver Display
SPEED SETTINGS
SOURCE:
SIM. SPEED
SPEED:
5.0 MPH
Figure 4-6: Source: Simulated Speed Display
TABLE OF CONTENTS
BACK
IMP. SWITCH:
DISABLED
SWITCH
SETTING
BACK
IMP. SWITCH:
DISABLED
SWITCH
SETTING
BACK
IMP. SWITCH:
DISABLED
SWITCH
SETTING
BACK
IMP. SWITCH:
DISABLED
SWITCH
SETTING
Speed Source Icon Features
Pulses Per Revolution
Pulses Per Revolution are the
number of magnets the implement
mounted speed sensor sees in one
revolution of the shaft being monitored. For Brillion
Seeders this number is 4.
To change, enter a new number into the keypad and
select "Exit & Save".
Wheel Pulses Per 400FT
This is the ground speed calibration
number for a implement mounted
speed sensor. See "Speed
Calibration" for calibration instructions.
The Default number is 90.
To change, enter a new number into the keypad and
select "Exit & Save". Increasing this number will cause
the monitor to show a slower MPH, decreasing it causes
the MPH to increase.
Radar Pulses Per 400FT
This is the ground speed calibration
number for a radar speed sensor.
See "Speed Calibration" for
calibration instructions.
Speed (Simulated Speed)
Enter the static speed of your
choice. The monitor will continually
display this speed at all times until
otherwise specified.
PULSES PER
REV:
4
WHEEL PULSES
PER 400FT:
90
MUST BE CHANGED
to 358.
RADAR PULSES
PER 400FT:
15815
SPEED:
5.0 MPH
4-3
Advertisement
