Introduction; General Safety - Thermo Scientific PrintMate A79510100 Operator's Manual

Safety Information

Introduction

Thermo Fisher Scientific products are designed for convenient and reliable service; however, incorrect actions by a
user may damage the equipment, or cause a hazard to health.
The following sections contain important information for the safe setup and use of the instrument.
All users must read and understand the following sections before using the instrument.

General Safety

This instrument, as supplied, conforms with IEC61010-1 and IEC61010-2-100; however, the addition of
chemical introduces potential hazards.
As with all scientific equipment, due care and good laboratory practice must be employed when dealing with these
chemicals, and consideration must be given to the potential for hazard when dealing with particular chemicals.
Be aware that many of the reagents used with this instrument may be flammable. Do not introduce any source of
ignition into, or near, the instrument once it has been loaded with reagents.
Do not remove any panels or covers. The instrument does not have any user serviceable parts.
The instrument must be properly connected to a good earth (ground) via the Mains input supply.
Position the instrument such that it is possible to interrupt the Mains supply at the source by removing the plug
from the socket.
If the equipment is used in a manner not specified by Thermo Fisher Scientific, the protection offered by the
equipment may be impaired.
Make sure that there is at least 100mm (4in) clearance around any fan inlets on the instrument.
In compliance with statutory requirements all our equipment is designed to accepted standards of safety. Its use
does not entail any hazard if operated in accordance with the instructions given in the documentation. However,
the following safety precautions must be obeyed:

All users must have read and understood the Operator Guide and these safety instructions; and only
operate the unit in accordance with the instructions.

Potentially lethal voltages above 110V a.c. or 50V d.c. are present inside the instrument. Do not remove
any access covers unless specifically instructed to do so.

It is important that normal standards of safety and good laboratory practices are employed. Always use
common sense when operating the instrument.

Any problems and queries should be referred to your Thermo Fisher Scientific supplier.

Correct maintenance procedures are essential for consistent performance. It is recommended that a
Maintenance Contract is taken out with our Service Department.

Use only factory approved accessories or replacement parts with this instrument.

Only use reagents recommended in the Operator Guide.
1