Thermo Scientific PrintMate A79510100 Operator's Manual page 45

Electrical Connections and Start-Up Procedure
Note
The following instructions assume that the LabWriter Application has been pre-installed. If this is not the case
refer to the LabWriter Operator Guide (A79510105) Chapter 1 - Installing the Software.
The PC and PrintMate should be connected as follows:

Set up the PC as described in the manufacturers' instructions.

Ensure the Power Switch on PrintMate is set to the Off (O) position.

Connect the Power Lead to the Power Connector and then plug it in to a suitably rated Mains Power
Supply.

Power up the PC so that the Windows Desktop is shown.

Ensure the LabWriter Application is correctly installed onto the PC.
Warning Do not run the LabWriter Application yet.

Turn on PrintMate and wait until the Touch Panel Display reads PrintMate Ready.

Connect the USB (Type A) Connector to the PC.
Operator Guide
37