Vistalink Monitored Parameters; Vistalink Controlled Parameters; Vistalink Traps; Table 6-1: Vistalink Monitored Parameters - evertz 7700 Manual

6.2. VISTALINK MONITORED PARAMETERS
®
The following parameters can be remotely monitored through the VistaLINK
Parameter
Card Type
Master Jumper
Optical Power
Video Standard
6.3. VISTALINK CONTROLLED PARAMETERS
®
When the MASTER jumper is set to the REMOTE position, the following parameters can be remotely
controlled through the VistaLINK
local jumper settings will override the settings configured through the VistaLINK
Parameter
Reclock Mode
Rate Mode
6.4. VISTALINK

TRAPS

®
The following parameters can be remotely enabled and monitored through the VistaLINK
traps in the Alarm View.
Trap
Signal Present
Carrier Weak
EDH Error
7707OE-HD SD/HD Re-Clocking Fiber to Electrical Converter
Description
Indicates either 7707OE-HD or 7707OE-HD-H card type.
The state of the MASTER jumper. When in REMOTE
position the cad functions are controlled through the
VistaLINK
®
A range of values describing optical power at the fiber
input.
A range of values describing the detected video standard.
Table 6–1: VistaLINK
interface. When the MASTER jumper is set to the LOCAL position the
®
Description
Enables or disables signal reclocking.
Sets the reclocking rate to SMPTE 259M, SMPTE 292M
or SMPTE310M rates.
Table 6–2: VistaLINK
®
Description
Indicates the presence of a valid input signal (the state of
the SIGNAL VALID LED).
Indicates a weak signal carrier (2dBm before maximum
input sensitivity) at the Fiber input (the state of the
CARRIER FAULT LED).
The status of EDH errors present in the input signal.
Table 6–3: VistaLINK
Revision 1.2.2
7700 MultiFrame Manual
interface
Monitored Parameters
®
Controlled Parameters
Traps
®
interface.
®
interface.
®
interface as
®
7707OE-HD-11