Specific Events; Switches, Jumpers, Options; Act Net Network Details - Carrier VVT Zone II Installation And Startup Manual

To adjust the driver properties

Specific Events

On these pages, you can enable/disable, change BACnet alarm properties, or set delays for the following BACnet
alarms:
Specific alarms:
•
Flow Control Alarm
•
Reheat Valve Alarm (future use)
NOTES
•
To set up alarm actions for controller generated alarms, see See Alarms in i-Vu® Help.
•
Reheat Valve Alarms are for future use.
Module Generated Alarm
Description
Events
Alarm Category and Alarm
Template
Enable
Notification Class

Switches, Jumpers, Options

The Switches, Jumpers, Options page shows the current physical settings on the VVT Zone II.

Act Net Network Details

Act Net Statistics
The actuator serial numbers are automatically read and filled in by the i-Vu® application. Only those devices that
are physically connected or in the control program will show in the table.
NOTE See To get the Carrier VVT Zone II serial number (page 62) for the controller serial number.
The Act Net network shows the VVT Zone II's actuator has Address 1.
CAUTION If you see Duplicate address on network or No communication with device under Device Status,
contact Carrier Control Systems Support. Do not use Act Net Address Setting unless directed by Carrier Control
Systems Support.
VVT Zone II Controller
Installation and Start-up Guide
Short message shown on the i-Vu® Alarms page or in an alarm action when this
type of alarm is generated.
See Alarms in i-Vu® Help.
Clear these checkboxes to disable Alarm or Return to normal messages of this
type from this controller.
Do not change this field.
60
CARRIER CORPORATION ©2019
All rights reserved