Wago Webserver I/O Field; Table 28 Parameterization Overview - WAGO 765-1205/0100-0000 Manual

Functions
2. The port configuration: digital input or output
The following table shows which tool can influence which section.
Tool
EtherCAT
WAGO I/O Field Web-
server
WAGO I/O Field App
Note
Parameters via EtherCAT
Each time EtherCAT
and parameters to the module. Port configuration parameters that were set by the WAGO
I/O Field Webserver, the WAGO I/O Field app or the OPC UA client are overwritten.
If you have changed parameters of the port configuration via the WAGO I/O Field Web-
server, the WAGO I/O Field app or the OPC UA Client, please note that these changes
are initially applied by the module, but the EtherCAT
ration again the next time it starts up. If you want to change parameters of the port config-
uration, set them in the configuration software of the EtherCAT

5.5.2 WAGO Webserver I/O Field

The WAGO I/O System Field module has an integrated Webserver. It can be accessed
with a standard Web browser in order to use the following functions:
• Display port information for ports X01, X02 etc.
• Display and modify module settings.
• User setup and management, as well as user login and logout
• Reset module to factory settings and restart firmware.
• Simulating inputs; forcing outputs
Examples of port information include:
• Display current measured values of the digital inputs and outputs: temperature, volt-
age, current and status on pins 1, 2 and 4
• Display the status information for the entire port
• Configure ports, e.g. set operating mode
• Show process data
The module settings include:
• Select method for obtaining IP address
• Select the origin of the configuration data used
• Display and enter maintenance information
• Reset module to factory settings.
• Load firmware onto the module
• Display and set parameters for Bluetooth
• Update Bluetooth
28 Product manual | Version: 1.0.0
8DIO FLD EC DC 24V 2.0A
®
EtherCAT Module
®
Master The EtherCAT
configures the 765 Series
module.
–
–
®
are always rewritten upon restart
®
communication starts up, the master transfers the configuration
®
firmware
Port Configuration
® ®
master The EtherCAT master sets the parameter selected by
the user on the basis of the parameters in the XML file
WAGO_series765.xml. These parameters configure
each individual port and determine whether the port is
used as a digital input or digital output (or is disabled).
Yes
Yes
®
master overwrites the port configu-
®
connection to the module
765-1205/0100-0000
Table 28: Parameterization Overview
®
master.