Configure Ports; Table 40 Port Configuration Settings - WAGO 765-1205/0100-0000 Manual

765-1205/0100-0000

10.3.1.4.1 Configure Ports

Name
Port mode (pin 4)
Digital input signal filter
(pin 4)
Port mode (pin 2)
Digital input signal filter
(pin 2)
Changes to settings require operator or admin rights. If you do not have these, the Con-
figuration tab is grayed out, and the displayed values cannot be edited.
If the controller and module are exchanging process data, configuration is not possible. In
this case, a message appears:
Note: Changing configuration not allowed because interface state
is "communicating."
To makes changes to a port's configuration, proceed as follows:
1. Select the desired port (port X01, port X02 etc.) from the menu.
2. Open the Configuration tab.
3. Configure pin 4 by setting the port operating mode.
4. Configure pin 2 by setting the port operating mode.
5. Configure the filter time for the digital input signals for pin 4 and pin 2.
6. Click the Apply button.
ð Your changes now take effect.
Configuring the Operating Mode for Pin 4 of the Port
You can select the port operating mode for pin 4 of the selected port from the Port mode
drop-down menu. The following operating modes are available:
Product manual | Version: 1.0.0
8DIO FLD EC DC 24V 2.0A
Type Description
Drop-down menu Port operating mode (configuration of pin 4)
Drop-down menu Filter time for digital input signals on pin 4 (only for
"Port mode (pin 4)" on digital input)
Drop-down menu Port operating mode (configuration of pin 2)
Drop-down menu Filter time for digital input signals on pin 4 (only for
"Port mode (pin 2)" on digital input)
Figure 14: Port XX Menu Item, Configuration Tab
Table 40: Port Configuration Settings
Commissioning
61