Fitting The Connector - ABB OmniCore E10 Product Manual

3 Installation and commissioning

3.5.4 Fitting the connector

3.5.4 Fitting the connector
General
This section describes how to manufacture a cable for connecting the main power
to the controller.
Connector
Connector AC power
inlet
Specifications
The following describes the cable requirements for the main power connection to
the OmniCore E10 controller.
Component
Cable type
Cable area
72
Connector article
number
3HAC077706-001
Description
Flexible oil resistant rubber
2
3C x 1.5 mm or AWG16
© Copyright 2019-2022 ABB. All rights reserved.
Description
IEC 60320 C19 connector
As this is a standard connector, it is sug-
gested to use the normal method to fit the
connector.
Product manual - OmniCore E10
3HAC079399-001 Revision: C