Electrical Connections; Connectors On The Omnicore E10 Controller - ABB OmniCore E10 Product Manual

3 Installation and commissioning

3.5.1 Connectors on the OmniCore E10 controller

3.5 Electrical connections

3.5.1 Connectors on the OmniCore E10 controller
General
The following section describes the connectors on the front panel of the OmniCore
E10 controller.
Connectors
The following illustration shows the connection interface on the controller.
xx2100001299
A
B
C
D
Continues on next page
62
CAUTION
Always inspect connectors for dirt or damage before connecting them to the
controller. Clean or replace any damaged parts.
Description
Power inlet switch
Power inlet connector
Manipulator signal connector (SMB)
Motor connector
© Copyright 2019-2022 ABB. All rights reserved.
Label Reference on
the circuit dia-
gram
Power Q0
X0 X0
X2 X2
X1 X1
Product manual - OmniCore E10
3HAC079399-001 Revision: C