Maintenance; Maintenance Schedule, Omnicore - ABB OmniCore E10 Product Manual

4 Maintenance

4.1 Maintenance schedule, OmniCore

General
The controller must be maintained at regular intervals to ensure its function. The
activities and intervals are described in this section.
Activities and intervals
Equipment
Complete controller
System fans
Control cabinet
FlexPendant
Emergency stop
(FlexPendant)
Manual, auto and
manual full speed
mode with FlexPend-
ant
Enable device
Safety switches
Auto stop (tested if
used)
General stop (tested
if used)
External emergency
stop (tested if used)
ESTOP_STATUS
output (tested if
used)
Reduced speed
control
i
Function test after replacement of component
After replacing a component in the controller, the function tests should be
performed. See
Product manual - OmniCore E10
3HAC079399-001 Revision: C
Maintenance
activity
Inspection
Inspection
Cleaning
Cleaning
Function test
Function test
Function test
Function test
Function test
Function test
Function test
Function test
Function test
The interval depends on the working environment of the equipment: a cleaner environment may
extend the maintenance interval and vice versa.
Function tests on page
© Copyright 2019-2022 ABB. All rights reserved.
4.1 Maintenance schedule, OmniCore
Interval Detailed in section:
i
12 months Inspecting the OmniCore E10 con-
troller on page 106
i
6 months Inspecting the OmniCore E10 con-
troller on page 106
Cleaning of the controller cabinet
on page 107
When needed Cleaning the FlexPendant on
page 108
12 months Function test of emergency stop on
page 110
12 months Function test of manual, auto, and
manual full speed mode with Flex-
Pendant on page 111
12 months Function test of three-position en-
abling device on page 112
12 months Function test of safety switches on
page 113
12 months Function test of Automatic Stop on
page 114
12 months Function test of General Stop on
page 115
12 months Function test of external emergency
stop on page 116
12 months Function test of ESTOP_STATUS
output on page 117
During commis- Function test of reduced speed
sioning control on page
110.
4 Maintenance
118.
105