Control Lock; Identifying The Device; Toggling The Dark Mode Setting; Setting The Delay Of The Dark Mode Setting - Lightware MMX4x2 Series User Manual

   
7. LW3 Programmers' Reference
7.4.7. Control Lock
Enable/disable the operation of the front panel buttons.
Command and Response #lockbutton
SET·/MANAGEMENT/UI.ControlLock=<lock_status>
ç
æ pw·/MANAGEMENT/UI.ControlLock=
Parameters
Parameter Parameter description Values
<lock_status> Front panel button
locking status
Example
ç SET /MANAGEMENT/UI.ControlLock=1
æ pw /MANAGEMENT/UI.ControlLock=1
7.4.8. Identifying the Device
Calling the method makes the status LEDs blink for 10 seconds. The feature helps to find the device physically.
Command and Response #identifyme
ç CALL·/MANAGEMENT/UI:identifyMe()
æ mO·/MANAGEMENT/UI:identifyMe
Example
ç CALL /MANAGEMENT/UI:identifyMe()
æ mO /MANAGEMENT/UI/identifyMe
#buttonlock
<lock_status>
Value description
0 None: all functions of the front panel button are enabled.
The front panel buttons are locked but can be unlocked
1
by a button combination. See the details in the
Lock section.
The front panel buttons are locked and cannot be
2
unlocked by a button combination, only in LDC (on the
Status tab) or using the LW3 command.
Applied firmware package: v1.6.0b19 | LDC software: v2.5.13b5
MMX4x2 series – User's Manual
7.4.9. Toggling the Dark Mode Setting
DIFFERENCE:

The LEDs of the device can be switched off in case their light could be annoying. In Dark mode, all LEDs are
switched off, except the LEDs of the RJ45 connectors (Ethernet and TPS in).
Command and Response
SET·/MANAGEMENT/UI/DARKMODE.DarkModeEnable=<mode_state>
ç
pw·/MANAGEMENT/UI/DARKMODE.DarkModeEnable=<mode_state>
æ
Parameters
If the <mode_state>
the function is disabled.
Control
Example
ç SET /MANAGEMENT/UI/DARKMODE.DarkModeEnable=true
æ pw /MANAGEMENT/UI/DARKMODE.DarkModeEnable=true
7.4.10. Setting the Delay of the Dark Mode Setting

DIFFERENCE:
The Dark mode can be enabled right away, or after a certain time. Thus the mode is enabled if no buttons
are pressed for a while. Pressing any button brings back the status info on the LEDs without performing the
function of the button itself. The delay time can be set by this command.
Command and Response
SET·/MANAGEMENT/UI/DARKMODE.DarkModeDelay=<delay_time>
ç
pw·/MANAGEMENT/UI/DARKMODE.DarkModeDelay=<delay_time>
æ
Parameters
The <delay_time>
and the Dark mode can be enabled immediately by the DarkModeEnable property. This delay affects the
wakeFromDarkMode method as well.
Example
ç SET /MANAGEMENT/UI/DARKMODE.DarkModeDelay=5
æ pw /MANAGEMENT/UI/DARKMODE.DarkModeDelay=5
This command is available from firmware v1.6.0b19.
parameter is true (or 1), the Dark mode function is enabled, if the parameter is false (or 0),
This command is available from firmware v1.6.0b19.
parameter means seconds, and the default value is 60. If set to 0, no delay is applied
87
#darkmode