FIGURE 4-29
4. Once the card is properly positioned as described above and seated properly to
the PCI board PCI Bus connector, tighten the locking thumbscrew.
Note – Some PCI cards may not require the standoffs provided for mounting.
5. Ensure that the standoff is positioned to capture the edge of the PCI card, and
then tighten the screw securing the standoff.
6. Use the procedures in the Section 4.5.3 "Installing a Board" on page 4-11, to
replace the I/O+ board.
4.5.7.3
Replacing Riser Cards
1. Use the procedures in Section 4.5.2 "Removing a Board" on page 4-8, to remove
the applicable I/O+ board.
2. If a PCI card is already installed in the slot designated for replacement of the riser
card, remove the card as indicated in Section 4.5.7.1 "Removing a PCI Card" on
page 4-29.
If there is no PCI card presently installed, proceed to Step 3.
PCI Card Installation/Replacement
Catch mechanism
Chapter 4
I/O+ Boards and Components
4-33