Disk Drives - Sun Microsystems Enterprise 6500 Reference Manual

5.5.2.4 Cabling Issues for Enterprise 6500 Systems
Slot 15 installation
1. Use an 80-cm SCSI cable to connect the Disk board to the SCSI Host Adapter
(onboard or SBus card).
2. Install a SCSI terminator on the disk board if it is the last (or only) board in the
SCSI chain.
Slot 14 installation
1. Connect the Disk board to the SCSI Host Adapter (onboard or SBus card):
If an I/O+ board is installed in the front, use an 80-cm SCSI cable to connect the
Disk board to the SCSI Host Adapter.
If all I/O+ boards are installed in the rear, use a 2-meter SCSI cable (sold
separately) to connect the Disk board to the SCSI Host Adapter.
Route the cable down the side of the card cage, through the cable pass in the
cabinet.
2. Install a SCSI terminator on the disk board if it is the last (or only) board in the
SCSI chain.
5.5.3

Disk Drives

5.5.3.1 Removing a Disk Drive
1. Use the procedures described in, Section 5.5.1 "Removing a Board," To remove the
applicable Disk board.
2. Unlatch and open the ejector drive retainer on the drive to be replaced
(
FIGURE 5-8
Using the extended drive retainer as a handle pull the drive straight out to
disengage it from the board mating receptacle and the drive mounting bracket.
5-12 Sun Enterprise 6500/5500/4500 Systems Reference Manual • April 1998
).