Defective Disk Drive - Sun Microsystems Enterprise 6500 Reference Manual

10.6

Defective Disk Drive

Begin
INDICATION
System error message or
device code identifies a
specific fault
Device not identified or
intermittent problem
End
FIGURE 10-6
TEST/PROCEDURE
Check system messages to
locate failed drive.
Halt access to device and power
down the device or tray.
Set ID code (if used) on
replacement device before
installing.
If replaced unit is SPARCstorage
Array disk tray or the tray
controller board, reset
world-wide name (WWN).
Run SunVTS.
For SCSI device, use OpenBoot
probe-scsi-all.
Check cable connection.
If replaced unit is SPARCstorage
Array disk tray or the tray
controller board, reset
world-wide name (WWN).
Diagnosing Disk Drive Problems
REFERENCE
Internal drives: Chapter 7.
See
Refer to SPARCstorage Array
Refer to SunVTS User's
Chapter 10 Flow Diagrams for Troubleshooting
Tray: tray service
manual.
, or refer to
TABLE C-2
drive or tray
documentation for ID
code.
documentation.
Guide.
10-7