Figure 3-10 Ultrasparc Ii Module Removal And Replacement - Sun Microsystems Enterprise 6500 Reference Manual

3. Lift the module straight up, off the board mating surface and the single standoff
that locks the module to the board.
Use pressure applied with fingers to assist in removing module from standoff
(
FIGURE 3-10
Standoff
1 per module
FIGURE 3-10
4. Place the module in an antistatic bag.
3.4.4.2 Installing a Module
To maximize performance when installing UltraSPARC II modules on a CPU/
Memory+ board, use all CPU 0 connectors on the lowest numbered slot to the
highest numbered slot. If there are modules remaining, use the CPU 1 connectors in
the same order.
Note – Screws on the UltraSPARC II modules must be tightened to 6 inch-pounds.
The torque screwdriver that came with your system is set to this specification.
3-14 Sun Enterprise 6500/5500/4500 Systems Reference Manual • April 1998
).
,
UltraSPARC II Module Removal and Replacement