Figure 4-22 Removing Or Installing A Graphics (Upa) Card - Sun Microsystems Enterprise 6500 Reference Manual

5. Hold the card by the edges near the connector and gently rock the card back and
forth to loosen it from the socket.
You may have to remove the SBus cards next to this card in order to have enough
room to hold onto the graphics (UPA) card being removed.
Caution – The connector housing may break if the card is tilted too far.
6. Lift the card from the socket at an angle while guiding the face plate out from the
back panel opening (
FIGURE 4-22
7. Place the card in an antistatic bag.
8. If the graphics (UPA) card is not immediately replaced, install a filler panel (part
number 340-2305) on the Graphics+ I/O board back panel opening. To secure the
filler panel, use the screws that were removed in Step 3.
Caution – Be sure to install the filler panel right-side up. Installing it upside down
creates a gap at the top edge of the card slot opening that can impair system cooling
and regulatory compliance.
9. Use the procedures in Section 4.5.3 "Installing a Board," to replace the Graphics+
I/O board.
4-24 Sun Enterprise 6500/5500/4500 Systems Reference Manual • April 1998
FIGURE 4-22
Removing or Installing a Graphics (UPA) Card
).