FIGURE E-12
4. Pull and slowly remove the SCSI adapter assembly from the cabinet.
E.2.6.2
Replacing the SCSI Adapter Assembly
1. Carefully insert the SCSI adapter assembly into the front of the Enterprise system.
Caution – DO NOT FORCE the SCSI adapter assembly into the slot; this can cause
damage to the assembly and system.
The SCSI adapter assembly should insert and seat smoothly. If it binds, remove it,
and inspect the slot for any obvious obstructions. Do not damage the springfingers
at the bottom of the assembly.
2. Tighten the three captive screws on the bottom that secure the SCSI adapter
assembly to the cabinet (
3. Connect the two cable assemblies to the front of the SCSI adapter assembly
(
FIGURE E-6
Removing the SCSI Tape Adapter PCS Assembly in the Enterprise 6500/5500
Systems
FIGURE E-12
).
Appendix E
).
Non-Chassis Field Replaceable Units (FRUs)
E-17