Figure 4-8 Extraction Lever In Extract Position - Sun Microsystems Enterprise 6500 Reference Manual

FIGURE 4-8
5. If a board is not immediately replaced, a load board (Enterprise 6500 systems
only) or a filler panel (Enterprise 4500 and 5500 systems only) must be installed in
its place.
See Section 4.2 "Filler Panels and Load Boards."
4.5.2.2 Removing a Board from a Powered-Off System
1. Use a Phillips #1 screwdriver to mechanically release the board from the system
card cage.
Insert the screwdriver into each quarter-turn access slot (the slots are located on the
left and right sides of the board front panel) and then turn a quarter turn so that the
arrow points to the unlocked position (
2. Unfasten any cable connectors from the front panel and set them aside.
Label cables to identify them for reconnection later.
3. Pull the ends of both extraction levers outward simultaneously to unseat the
board from the centerplane receptacles (
4-10 Sun Enterprise 6500/5500/4500 Systems Reference Manual • April 1998
Extraction Lever in Extract Position
Extraction lever in
extract/insert position
).
FIGURE 4-7
).
FIGURE 4-8