Figure 8-5 Cd-Rom/Tape Drive Removal And Replacement - Sun Microsystems Enterprise 6500 Reference Manual

FIGURE 8-5
6. After the cabling is removed, remove the device enclosure from the media tray.
7. To remove a drive:
CD-ROM drive: remove two screws from each side where the device is secured to
the device enclosure. Proceed to Step 9.
Tape drive: remove 2 screws from each side where the tape is fastened to the
device enclosure, and then remove 4 screws securing the device to the enclosure
side plate. Proceed to Step 9.
8. To install a tape drive in an unused slot:
a. Remove the filler panel from the device enclosure by loosening and removing 4
screws.
b. Use the 4 screws to secure the tape drive to the device enclosure.
9. On the replacement device set the SCSI ID address to 6 (for a CD-ROM drive) or
5 (for a tape drive).
10. To complete installation of a CD-ROM or tape drive, reverse Step 2 through
Step 5.
8-6 Sun Enterprise 6500/5500/4500 Systems Reference Manual • April 1998
CD-ROM/Tape Drive Removal and Replacement