Enterprise 6500/5500 Tape Or Cd-Rom Drive; Figure 8-4 Removing The Top Front Panel - Sun Microsystems Enterprise 6500 Reference Manual

8.2.2

Enterprise 6500/5500 Tape or CD-ROM Drive

To remove and replace an existing device, perform steps 1 through 5. To install a
tape device for the first time, proceed to step 6.
Caution – To prevent breakage, do not grasp the panel by the bottom edge.
1. Remove the key from the key switch.
2. Remove the top panel.
Grasp the panel on both sides at the top and pull to disengage the ball studs
(
FIGURE 8-4
FIGURE 8-4
Note – It is not necessary to remove the media tray to replace a device; it is only
necessary to remove the device enclosure from the media tray.
3. Remove the left side panel.
See Section 12.3.6 "Side Panels" for removal instructions.
4. Release the device enclosure from the media tray by removing three screws on the
left side of the media tray (
5. Pull the device enclosure forward and disconnect the data and power cables from
the rear of each device.
).
Removing the Top Front Panel
FIGURE 8-5
).
Chapter 8 Internal SCSI and Storage Devices 8-5