Graphics (Upa) Cards; Figure 4-21 Graphics (Upa) Card Connector Location - Sun Microsystems Enterprise 6500 Reference Manual

11. Replace and tighten the back panel screws to secure the SBus card to the I/O+
board back panel.
12. Replace the I/O+ board using the procedures described in Section 4.5.3 "Installing
a Board."
4.5.5

Graphics (UPA) Cards

The Graphics+ I/O board contains a single connector that accommodates graphics
(UPA) cards (
FIGURE 4-21
4.5.5.1 Removing a Graphics (UPA) Card
1. Use the procedures in Section 4.5.2 "Removing a Board," to remove the applicable
Graphics+ I/O board.
2. Locate the card (
3. Remove the two screws that secure the card to the Graphics+ I/O board front
panel.
Save the screws for installation of a replacement card or a filler panel.
4. Unlock the card by pulling up the tips of the two standoffs (
).
FIGURE 4-21
Graphics (UPA) Card Connector Location
).
FIGURE 4-22
UPA connector
FIGURE 4-14
Chapter 4 I/O+ Boards and Components
).
4-23