Figure 5-4 Unlocking And Locking Quarter-Turn Access Slots; Figure 5-5 Disk Board - Sun Microsystems Enterprise 6500 Reference Manual

3. Use a Phillips #1 screwdriver to mechanically release the board from the system
card cage.
Insert the screwdriver into each quarter-turn access slot (the slots are located on the
left and right sides of the board's front panel) and then turn a quarter turn so that
the arrow points to the unlocked position (
Unlocked
Unlocking and Locking Quarter-Turn Access Slots
FIGURE 5-4
4. Pull the ends of both extraction levers outward simultaneously to unseat the
board centerplane connector from the centerplane receptacles (
Disk Board
FIGURE 5-5
5. If a board is not immediately replaced, a filler panel or a load board (for
Enterprise 6500 systems only) must be installed in its place.
See Section 5.2 "Filler Panels and Load Boards."
).
FIGURE 5-4
Locked
Extraction lever
in extract/insert
position
Chapter 5 Disk Boards and Components
).
FIGURE 5-5
5-7