Under-Desk Mounting - Extron electronics SSP 7.1 User Manual

Mounting, cont'd

Under-desk mounting

To mount the SSP 7.1 under a desk or podium, using the optional Extron MBU 125
under desk mounting kit (part # 70-077-01), follow these instructions:
1. Remove rubber feet if these have been installed on the bottom of the unit.
2. Secure the mounting brackets to the unit, using the four 4-40 screws provided
Under-desk mounting the SSP 7.1
3. Hold the unit with the brackets attached against the underside of the table
4. Drill four pilot holes, each 3/32" (2.4 mm) in diameter by 1/4" (6.3 mm) deep in
5. Insert #8 wood screws into the four pilot holes. Tighten each screw into the
6. Guide the mounting screws through the slots in the brackets and place the unit
7. Slide the unit slightly in or out so that it is held in place by the screws; tighten all
2-4 SSP 7.1 • Mounting
(see the figure below).
or other furniture. Mark the location of the screw holes of the bracket on the
mounting surface.
the mounting surface at the marked screw locations.
mounting surface until just less than 1/4" (6.3 mm) of the screw head protrudes.
tight against the surface.
four screws to secure the unit in place (see the figure above).