Under-Desk Mounting; Through-Desk Mounting - Extron electronics DVI-RGB 150 User Manual

Installation and Operation, cont'd

Under-desk mounting

Mount the unit under a desk or podium using the optional
Extron MBU 125 under desk mounting kit (part #70-077-01) as
follows:
1. If rubber feet were previously installed on the bottom of
the unit, remove them.
2. Attach the mounting brackets to the interface with the
machine screws provided (fi gure 2-3).
Figure 2-3 — Under-desk mounting the interface
3. Hold the unit with the brackets attached against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
Drill four pilot holes, each 3/32" (2 mm) in diameter by
4.
1/4" deep (6.3 mm) deep in the mounting surface at the
marked screw locations.
5. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" (6.3 mm) of the screw head protrudes.
6. Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
7. Slide the unit slightly in or out, then tighten all four screws
to secure the unit in place (fi gure 2-3).
2-4 DVI-RGB 150 • Installation and Operation

Through-desk mounting

Mount the unit through a desk or podium using the optional
Extron MBD 129 through desk mounting kit (part #70-077-02) as
follows:
1. If rubber feet were previously installed on the bottom of
the unit, remove them.
2. Secure the brackets to the interface with the provided
machine screws (fi gure 2-4). Leave the screws slightly loose.
Figure 2-4 — Through-desk mounting the interface
Hold the interface and brackets on the underside of the
3.
surface to which you are mounting the device and mark
the four screw holes and the table material to be removed.
4. Remove the table material. Test the fi t by inserting the
front of the device through the hole. If necessary, use a
rasp or coarse fi le to enlarge the hole.
5. Drill four pilot holes, each 3/32" (2 mm) in diameter by
1/4" deep (6.3 mm) deep , as marked on the template.
6. Using the four wood screws provided, attach the brackets
to the mounting surface.
DVI-RGB 150 • Installation and Operation 2-5