Extron electronics SSP 7.1 User Manual page 72

Configuration and Control, cont'd
Command
Output Channel Trim Settings
Set a specific Output
Channel Trim
View a specific Output
Channel Trim
Speaker Delay Settings
Set a specific speaker's
delay
View a specific speaker's
delay
Farthest Speaker Distance
Set farthest speaker's
distance
View farthest speaker's
distance
N This command is included for reference: it is for use with the SSP 7.1 Setup and Control Software only
Crossover Frequency Setting
Specify Crossover
Frequency
View Crossover Frequency
Volume Adjustment
Specify Volume
Increment Volume
Decrement Volume
View Volume setting
Bass Adjustment
Specify Bass Level
View Bass Level setting
6-10 6-10 SSP 7.1 • Configuration and Control
ASCII Command Response
(host to unit) (unit to host)
E X@ X3# }
V * SSP SspV
E X@ }
V SSP SspV
E X@ X1% }
D * SSP SspD
E X@ }
D SSP SspD
E X& }
K SSP SspK
E }
KSSP SspK
E X1& }
F SSP SspF
E }
FSSP SspF
X^
V Vol
+V
Vol
-V
Vol
V
Vol
E X% }
B SSP SspB
E }
BSSP SspB
X@ X3#]
*
X@ X3#]
*
X@ X1%]
*
X@ X1%]
*
X&]
X&]
X1&]
X1&]
X^]
X^]
X^]
X^]
X%]
X%]
Additional description
Set gain for the selected output:
X@
— Audio Outputs (1-8)
1 = Left front
2 = Center
3 = Right front
4 = Left surround side
5 = Right surround side
6 = Left surround back
7 = Right surround back
8 = Subwoofer
X3#
— Output gain and attenuation
readout in dB (-24 to +12; default = 0)
View the current gain setting for the
selected output
Set speaker delay for the selected output:
X1%
— Speaker delay (in 0.1 ms units;
default = 0 on all channels):
View the current speaker delay for the
selected output
Set Crossover Frequency
X1&
— Crossover Frequency 1 - 20
(default = 11; equivalent to 100 Hz)
1-9 = 40-80 Hz in 5 Hz increments
9-16 = 80-150 Hz in 10 Hz increments
16-20 = 150-250 Hz in 25 Hz increments
View Low Frequency Filter Status
X^
— Volume Adjustment 0 (-100 dB) to
100 (0 dB) in 1 dB steps, default = 50.
Max volume (no attenuation) = 100;
Min volume (full attenuation) = 0
Increments volume
Decrements volume
View the current volume setting
Sets the Bass level
X%
= -10 to +10 dB in 1 dB increments
(default = 0)
View the current Bass level setting