Selecting Speakers To Be Tested; Speaker Test Sequence - Extron electronics SSP 7.1 User Manual

Selecting speakers to be tested

The currently available speakers are displayed in a graphics box. Speakers that are
not available are not displayed.
Click on the individual speaker to select
or deselect it from the list of speakers to be
tested. Click on All to select all speakers.
N If all speakers have been selected,
clicking on All will deselect all
speakers.

Speaker test sequence

To run an automatic test sequence
1. Select the Auto button. This sends a two second test signal to each speaker
in the sequence shown in the diagram at the bottom of the page. All other
speakers are muted. If a channel does not have a speaker connected, that
channel will be skipped and the test signal will go to the next available channel
with a speaker.
2. The test sequence will continue to cycle through each of the speakers multiple
times if the test signal is not switched off. Click on Off in the "Select Signal
Type" area to switch off the test signal and end the test sequence.
To test the speakers manually:
1. Click on Auto to deselect it
2. Click on the forward (>) or back
(<) buttons to move forward or
backward through the sequence
shown in the diagram below.
3. Click on Off in the "Select
Signal Type" area to switch off
the test signal and end the test
sequence.
5.1 Setup 6.1 Setup
Left Front
channel
2 Sec
Center
channel
2 Sec
Right Front
channel
2 Sec
Right Side
2 Sec
channel
Center Back
2 Sec 2 Sec
2 Sec
Left Side
channel
2 Sec
Subwoofer
SSP 7.1 • Setup and Control Software
7.1 Setup
2 Sec
Right Back
Channel
2 Sec
Channel
Left Back
Channel
2 Sec
5-13 5-13