Panorama Control; Center Width Control; Dts Neo:6 Settings; Center Image Control - Extron electronics SSP 7.1 User Manual

Panorama Control

These buttons allow the user to switch the Panorama settings On or Off (default
Off). For more information about Panorama Control, see page 4-7.

Center Width Control

This sliding bar adjusts the Center Width Control in the range 0 - 7. Setting the
control to 0, allows the sound to come from the front center speaker. Setting the
control to 7, allows the sound to come from the front right and left speakers. The
default setting is 3. For more information, see page 4-6.

DTS Neo:6 Settings

These controls set the center image for DTS Neo:6
Cinema and DTS Neo:6 Music listening modes.
For more information about these listening modes,
see page B-9.

Center Image Control

The sliding bars adjust the center image control
settings for:
• DTS Neo6 Music: 0 - 10 (default 3)
• DTS Neo6 Cinema: 0 - 10 (default 10)
Setting the control to 0, creates the effect of
spreading out the audio signal across the front
speakers. Setting the control to 10, creates
the effect of centralizing the audio signal. For
information about the Center Image control, see
page 4-7.

Input/Output information bar

The Input/Output Status bar is available from all GUI tabs and is described in
detail on page 5-5.
SSP 7.1 • Setup and Control Software 5-19 5-19