Tone Controls; Analog Input Gain - Extron electronics SSP 7.1 User Manual

SSP 7.1 Setup and Control Software, cont'd

Tone Controls

Bass control adjusts the amount of low-
frequency boost or cut applied to the audio
outputs for all speakers, including the
subwoofer. Treble control adjusts the amount
of high-frequency boost or cut applied to
the audio outputs for all speakers, except
the subwoofer. Both controls are adjustable
between -10 dB and +10 dB and the current
value is shown in the text box. Adjust the
value in any of these ways:
•
•
•
•

Analog Input Gain

This control is only available when input 5 (analog) is
selected. It is locked and cannot be adjusted when inputs
1-4 are selected.
The Analog Input Gain control allows the gain to be
adjusted between 0 dB and +24 dB. The current setting is
displayed in the text box.
The gain can be changed in any of the following ways:
•
•
•
•
The red virtual LED lights when the input level goes
above 0 dBFS, indicating that the input level is too high.
N If the gain level is turned too high, clipping may occur (depending on the input
5-4 5-4 SSP 7.1 • Setup and Control Software
Grab and drag the slider bar to adjust tone
in 1 dB increments. Clicking on the control
(the vertical white line, not the bar) will
increment or decrement the value by 5 dB,
depending on whether the click was above
or below the bar.
Click on the tone control to bring it into focus and then use the up and down
arrows beside the text box to adjust the tone in 1 dB increments.
With the tone control in focus, use the up and down keys on the keyboard to
adjust the tone in 1 dB increments.
Alternatively, with the tone control in focus, use the page up and page down
keys on the keyboard to adjust the tone in 5 dB increments.
Grab and drag the slider bar to adjust gain in 1 dB
increments. Clicking on the control (the vertical white
line, not the bar) will increment or decrement the
value by 5 dB, depending on whether the click was
above or below the bar.
Click on the gain control to bring it into focus and then
use the up and down arrows beside the text box to
adjust the gain in 1 dB increments.
With the gain control in focus, use the up and down
keys on the keyboard to adjust the gain in 1 dB
increments.
Alternatively, with the gain control in focus, use the
page up and page down keys on the keyboard to
adjust the gain in 5 dB increments.
volume). When clipping occurs, the red virtual LED beside Input 5 button
lights.