Configuring Winnet; Adding Controller(S) To Locations Database; Illustration 21, "Controller Locations" Window; Illustration 22, "Add New Location" Window - Leightronix NET Series Manual

CONFIGURING WINNET

ADDING CONTROLLER(S) TO LOCATIONS DATABASE

Create an IP address listing of your NET Series Controllers as follows:
1. Click "Locations" in the "Tools" menu or the
the "Controller Locations" window shown in Illustration 21.
2. Click "Add" on the "Controller Locations" window (see Illustration 21, "Controller
Locations" Window) to open the "Add New Location" window shown in Illustration
22. Complete the following fields:
 "Name": type a name for your Controller.
 "IP Address": enter the IP Address displayed on the Controller's front panel.
This address can be viewed from the front panel by pressing the up or down
arrows until the IP Address is shown.
LEIGHTRONIX, INC.
2010-07-09

Illustration 21, "Controller Locations" Window

Illustration 22, "Add New Location" Window

Firmware Ver. 1.00.42/Software Ver. 1.0.2.6
Software Installation and Configuration
icon on the main toolbar to open
NET Series
Page 47