Editing Subnet Mask - Leightronix NET Series Manual

NET Series
Controller Installation and Configuration
IP ADDRESS CONFIGURATION STEPS
5. Press "→" or "←" to position the underscore
under the editable fields and press "↑" or "↓" to
edit the values.
6. Press "→" to enter next screen.
7. Either press "→" again to save your changes or
"←" to abort changes.
NOTE: Unit must be rebooted to apply any TCP/IP address changes (simultaneously press
"↓" and "→" and then press "↑"). Refer to "Rebooting Controller," on page 126.

EDITING SUBNET MASK

Obtain subnet mask address from your support personnel or network administrator.
See Table 8, Editing Subnet Mask from Front Panel, for editing instructions.
SUBNET MASK CONFIGURATION STEPS
1. From the "MAIN MENU" screen, press "↑" or "↓"
to proceed to "TCP/IP Configuration."
2. Press "→" to select "TCP/IP Configuration."
3. Press "↑" or "↓" to proceed to "Edit Subnet
Mask."
4. Press "→" to select "Edit Subnet Mask."
5. Press "→" or "←" to position the underscore
under the editable fields and press "↑" or "↓" to
edit the values.
6. Press "→" to enter next screen.
7. Either press "→" again to save your changes or
"←" to abort changes.
NOTE: Unit must be rebooted to apply any TCP/IP address changes (simultaneously press
"↓" and "→" and then press "↑"). Refer to "Rebooting Controller," on page 126.
Page 32
Table 8, Editing Subnet Mask from Front Panel
Firmware Ver. 1.00.42/Software Ver. 1.0.2.6
CORRESPONDING SCREEN DISPLAYS
Enter new IP address
0. 0. 0.
Press ~ to confirm
IP address.
CORRESPONDING SCREEN DISPLAYS
MAIN MENU
TCP/IP Configuration
IP CONFIG MENU
Edit Subnet Mask
Enter new Subnet Mask
255.255.255. 0
Press ~ to confirm
Subnet Mask.
0
Use `/ˆ
~
Use `/ˆ
~
~
LEIGHTRONIX, INC.
2010-07-09