Table of Contents
Advertisement
Chapter 4
Convenience Tray Removed
FIGURE 18.
Remove the convenience tray from the right-rear corner of the cab.
3.
Locate the connectors labeled POWER GND PORT and PRODUCT CAN on the machine's harness in the
4.
convenience tray compartment.
Connect the machine's POWER GND PORT to the mating 6-pin POWER connector on the node harness.
5.
Remove the dust cap from the 4-pin PRODUCT CAN connector on the machine's harness and connect it to
6.
the mating 4-pin CAN connector on the node harness.
Install the Foot Switch
Foot Switch Installed
FIGURE 19.
26
Case IH Titan 4030 and 4530, Model Year 2013 & Newer SmarTrax™ Installation Manual
Advertisement
Table of Contents
