Page 2
GPS, GNSS, SBAS, etc.). Therefore, Raven Industries cannot guarantee the accuracy, integrity, continuity, or availability of these services and cannot guarantee the ability to use Raven systems, or products used as components of systems, which rely upon the reception of these signals or availability of these services.
• Follow all safety information presented within this manual. • If you require assistance with any portion of the installation or service of your Raven equipment, contact your local Raven dealer for support. • Follow all safety labels affixed to the AutoBoom system components. Be sure to keep safety labels in good condition and replace any missing or damaged labels.
CAUTION Hydraulic Safety • Raven Industries recommends that appropriate protective equipment be worn at all times when working on the hydraulic system. • Never attempt to open or work on a hydraulic system with the equipment running. Care should always be taken when opening a system that has been previously pressurized.
During the installation process, follow good safety practices. Be sure to carefully read the instructions in this manual as you complete the installation process. Recommendations Raven Industries recommends the following best practices when installing the AutoBoom system. • Use part numbers to identify the parts.
Chapter 2 At Raven Industries, we strive to make your experience with our products as rewarding as possible. One way to improve this experience is to provide us with feedback on this manual. Your feedback will help shape the future of our product documentation and the overall service we provide.
I nstallation CHAPTER C h a p t e r 3 Note: If there is not sufficient clearance space to install the retrofit kit, it may be necessary to remove the axle from the boom. Gauge Wheel Assembly FIGURE 1. Remove the spring and shock assembly from the right cushioned wheel axle.
Page 10
Chapter 3 Retrofit Kit Installed FIGURE 2. Reinstalled Shock and Spring Assembly Slotted Spring Pin (P/N 312-0000-398) Axle Weldment Bracket (P/N 116-0159-750) Slotted Spring Pin Inserted Through Holes Drilled in Axle Walls and Bracket Insert the axle weldment bracket (P/N 116-0159-750) between the side walls of the axle. Clamp the bracket in place so that it is immoveable.
Page 11
Index Electrical Safety 2 Hydraulic Safety 2 Important Safety Information Electrical 2 Hydraulics 2 Introduction Kit Contents 4 Updates 3 Kit Contents Point of Reference Preparing for Installation Recommendations Tools Needed Manual No. 016-0171-122...
Page 12
Index Viper Pro Installation & Operation Manual...
Page 13
Bring the defective part and proof of purchase to your Raven dealer. If the dealer approves the warranty claim, the dealer will process the claim and send it to Raven Industries for final approval. The freight cost to Raven Industries will be the customer’s responsibility. The Return...
Page 14
How Can I Get Service? Bring the defective part and proof of purchase to your Raven dealer. If the dealer approves the warranty claim, the dealer will process the claim and send it to Raven Industries for final approval.