Installing The Front Wheel (Front Brake Disc) - Yamaha N MAX GPD150-A 2015 Service Manual

b. Turn the front wheel 90° so that the heavy
spot is positioned as shown.
c. If the heavy spot does not stay in that posi-
tion, install a heavier weight.
d. Repeat steps (b) and (c) until the front wheel
is balanced.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
4. Check:
• Front wheel static balance
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Turn the front wheel and make sure it stays at
each position shown.
b. If the front wheel does not remain stationary
at all of the positions, rebalance it.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS30154
INSTALLING THE FRONT WHEEL (FRONT
BRAKE DISC)
1. Install:
• Front brake disc "1"
• Front wheel sensor rotor "2"
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
ECA21011
NOTICE
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
• Replace the brake disc bolts and wheel
sensor rotor bolts with new ones.
TIP
• Install the brake disc with its chamfered side
"a" facing inward.
• Install the front wheel sensor rotor with the
stamped mark "b" facing away from the wheel.
• Tighten the bolts in stages.
1
▲▲▲
▼▼▼
2. Check:
▲▲▲
• Front brake disc
Refer to "CHECKING THE FRONT BRAKE
DISC" on page 4-42.
3. Lubricate:
• Wheel axle
4-30
FRONT WHEEL
Front wheel sensor rotor bolt
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
LOCTITE®
Front brake disc bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
LOCTITE®
b
Recommended lubricant
Lithium-soap-based grease
1
a
2