Yamaha N MAX GPD150-A 2015 Service Manual page 123

• Engine oil drain bolt "2"
(along with the gasket "3")
1
4. Drain:
• Engine oil
(completely from the crankcase)
5. If the oil strainer is also to be cleaned, per-
form the following procedure.
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Remove the oil strainer cover "1", spring "2",
and oil strainer "3".
b. Install a new O-ring "4".
TIP
Lubricate the O-ring with lithium-soap-based
grease.
3
2
New
4
1
c. Clean the engine oil strainer with solvent, and
then check it for damage and replace it if nec-
essary.
d. Install the oil strainer, spring, and oil strainer
cover.
3 2
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
PERIODIC MAINTENANCE
▲ ▲▲▲ ▲ ▲▲▲ ▲
6. Install:
• Engine oil drain bolt
(along with the gasket
7. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
Engine oil quantity
8. Install:
• Dipstick
9. Start the engine, warm it up for several min-
utes, and then turn it off.
10.Check:
• Engine
▼▼▼
(for engine oil leaks)
11.Check:
• Engine oil level
Refer to "CHECKING THE ENGINE OIL
LEVEL" on page 3-17.
12.Remove:
• Front side cover (right)
Refer to "GENERAL CHASSIS (2)" on page
4-4.
• Footrest board assembly (right)
Refer to "GENERAL CHASSIS (5)" on page
4-12.
13.Check:
• Engine oil pressure
▼ ▼▼▼ ▼ ▼▼▼ ▼
a. Slightly loosen the oil check bolt "1".
3-18
Oil strainer cover
32 Nm (3.2 m·kgf, 23 ft·lbf)
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
New
Engine oil drain bolt
20 Nm (2.0 m·kgf, 14 ft·lbf)
Quantity (disassembled)
1.00 L (1.06 US qt, 0.88 Imp.qt)
Periodic oil change
0.90 L (0.95 US qt, 0.79 Imp.qt)
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
▲ ▲▲▲ ▲ ▲▲▲
)
▼ ▼▼▼ ▼ ▼▼▼
1