Handlebar; Removing The Upper Handlebar Cover Assembly; Disassembling The Upper Handlebar Cover Assembly; Removing The Handlebar - Yamaha N MAX GPD150-A 2015 Service Manual

EAS31622
REMOVING THE UPPER HANDLEBAR
COVER ASSEMBLY
1. Remove:
• Upper handlebar cover assembly "1"
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Remove the quick fastener and upper han-
dlebar cover assembly screws.
b. Unhook the projections "a" on the upper han-
dlebar cover assembly from the slots "b" in
the lower handlebar cover.
a
b
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS31701
DISASSEMBLING THE UPPER HANDLEBAR
COVER ASSEMBLY
1. Disassemble:
• Upper handlebar panel "1"
• Upper handlebar cover "2"
TIP
Unhook the projections "a" on the upper handle-
bar panel from the slots "b" in the upper handle-
bar cover.
a
1
a
2
EAS30203

REMOVING THE HANDLEBAR

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Grip end
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a
1
b
a
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
b
b
TIP
While holding the grip end, loosen the grip end
bolt.
3. Remove:
▼▼▼
• Handlebar grip "1"
TIP
Blow compressed air between the handlebar
and the handlebar grip, and gradually push the
grip off the handlebar.
b
▲▲▲
EAS30204

CHECKING THE HANDLEBAR

1. Check:

• Handlebar

Bends/cracks/damage → Replace.
EWA13690
WARNING
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken it.
EAS30205

INSTALLING THE HANDLEBAR

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Install:
• Lower handlebar holders "1"
• Handlebar "2"
• Upper handlebar holders "3"
ECA18300
NOTICE
First, tighten the bolts on the front side of the
handlebar holder, and then on the rear side.
TIP
• Make sure that the projection "a" of the handle-
bar contacts the lower handlebar holder.
4-72
HANDLEBAR
Upper handlebar holder bolt
21 Nm (2.1 m·kgf, 15 ft·lbf)