Checking The Wheels; Checking The Tires - Yamaha N MAX GPD150-A 2015 Service Manual

Brake caliper bleed screw
6 Nm (0.6 m·kgf, 4.3 ft·lbf)
m. Fill the brake master cylinder reservoir to the
proper level with the specified brake fluid.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-10.
EWA13110
WARNING
After bleeding the hydraulic brake system,
check the brake operation.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS30638

CHECKING THE WHEELS

The following procedure applies to all of the
wheels.
1. Check:
• Wheel
Damage/out-of-round → Replace.
EWA13260
WARNING
Never attempt to make any repairs to the
wheel.
TIP
After a tire or wheel has been changed or re-
placed, always balance the wheel.
2. Measure:
• Radial wheel runout
• Lateral wheel runout
Refer to "CHECKING THE FRONT WHEEL"
on page 4-27 and "CHECKING THE REAR
WHEEL" on page 4-34.
EAS30640

CHECKING THE TIRES

The following procedure applies to all of the
tires.
1. Check:
• Tire pressure
Out of specification → Regulate.
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
PERIODIC MAINTENANCE
EWA13181
WARNING
• The tire pressure should only be checked
and regulated when the tire temperature
equals the ambient air temperature.
• The tire pressure and the suspension must
be adjusted according to the total weight
(including cargo, rider, passenger and ac-
cessories) and the anticipated riding
speed.
• Operation of an overloaded vehicle could
cause tire damage, an accident or an injury.
NEVER OVERLOAD THE VEHICLE.
▲▲▲
Tire air pressure (measured on
cold tires)
* Total weight of rider, passenger, cargo
and accessories
EWA13190
WARNING
It is dangerous to ride with a worn-out tire.
When the tire tread reaches the wear limit, re-
place the tire immediately.
2. Check:
• Tire surfaces
Damage/wear → Replace the tire.
1. Tire tread depth
2. Side wall
3. Wear indicator
3-13
Front (1 person)
150 kPa (1.50 kgf/cm², 22 psi)
Rear (1 person)
250 kPa (2.50 kgf/cm², 36 psi)
Front (2 persons)
150 kPa (1.50 kgf/cm², 22 psi)
Rear (2 persons)
250 kPa (2.50 kgf/cm², 36 psi)
Maximum load
150 kg (311 lb)