Yamaha N MAX GPD150-A 2015 Service Manual page 81

1. Main switch lead
2. Rectifier/regulator
3. Meter assembly lead
4. Turn signal relay
5. Turn signal relay lead
6. Headlight lead
7. Auxiliary light lead
8. Front turn signal light lead (front left turn signal
light)
9. Front wheel sensor lead
10. Front brake hose (hydraulic unit to front brake
caliper)
11. Wire harness
12. Rear brake hose (hydraulic unit to rear brake
caliper)
13. Hydraulic unit assembly lead
14. Hydraulic unit assembly
15. Front turn signal light lead (front right turn signal
light)
16. Meter assembly
17. Front wheel sensor coupler
18. Rear brake hose (rear brake master cylinder to
hydraulic unit)
19. Front brake hose (front brake master cylinder to
hydraulic unit)
20. Throttle cable (decelerator cable)
21. Throttle cable (accelerator cable)
22. Seat lock cable
23. Rectifier/regulator lead
24. Front turn signal light
A. After connecting the meter assembly coupler,
install the coupler cover completely until it contacts
the meter assembly.
B. Route the throttle cable (accelerator cable) to the
outside of the throttle cable (decelerator cable).
C. Route the front turn signal light lead as shown in
the illustration.
2-34
CABLE ROUTING