Yamaha N MAX GPD150-A 2015 Service Manual page 95

1. Rear brake hose (hydraulic unit to rear brake
caliper)
2. Rear wheel sensor lead
3. Fuel hose
4. Fuel tank overflow hose
5. Center lower cover
6. Coolant reservoir hose
7. Coolant reservoir breather hose
8. Fuel hose holder
9. O sensor lead
2
A. Install the hose completely onto the hose fitting.
B. Position the hose clamp 3
from the end of the hose. Point the ends of the
hose clamp upward.
C. Fasten the grommet on the fuel hose with the
holder.
D. Insert the end of the fuel tank overflow hose into
the center lower cover. Make sure that the end of
the hose protector on the fuel tank overflow hose
contacts the edge of the hole in the center lower
cover.
– –
7 mm (0.12 0.28 in)
2-48
CABLE ROUTING