Removing The Rear Side Cover Assembly; Installing The Rear Side Cover Assembly - Yamaha N MAX GPD150-A 2015 Service Manual

EAS31687
REMOVING THE REAR SIDE COVER
ASSEMBLY
The following procedure applies to both of the
rear side cover assembly.
1. Remove:
• Rear side cover assembly "1"
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Remove the quick fasteners, screw and bolt.
b. Remove the projections "a" on the rear side
cover assembly from the holes "b" in the stor-
age box.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS31688
INSTALLING THE REAR SIDE COVER
ASSEMBLY
The following procedure applies to both of the
rear side cover assembly.
1. Install:
• Rear side cover assembly "1"
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Fit the projections "a" on the rear side cover
assembly into the holes "b" in the storage
box.
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
b
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
b. Install the quick fasteners, screw, and bolt,
and then tighten the screw and bolts to spec-
ification.
▼▼▼
▲ ▲▲▲ ▲ ▲▲▲ ▲
1
a
▲▲▲
▼▼▼
4-11
GENERAL CHASSIS (4)
b
Rear side cover assembly screw
1.8 Nm (0.18 m·kgf, 1.3 ft·lbf)
Footrest board and rear side cov-
er bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
1
a
▲ ▲▲▲ ▲ ▲▲▲