Yamaha N MAX GPD150-A 2015 Service Manual page 87

1. Coolant temperature sensor lead
2. Throttle body sensor assembly lead
3. Starter motor lead
4. ISC (Idle Speed Control) unit lead
5. AC magneto lead
6. Fuel injector lead
7. O sensor lead
2
8. VVA (variable valve actuator) solenoid lead
9. Ignition coil
10. Rear brake hose (hydraulic unit to rear brake
caliper)
11. Rear wheel sensor lead
12. Fuel tank overflow tray
13. Rear wheel sensor coupler
14. Wire harness
15. Fuel hose
16. VVA (variable valve actuator) solenoid
17. Spark plug lead
18. Water pump inlet hose
19. Thermostat assembly
20. Radiator inlet hose
21. Sidestand switch lead
22. Fuel pump lead
23. Fuel pump
24. Ignition coil lead
A. Route the spark plug lead between the VVA
(variable valve actuator) solenoid and the water
pump inlet hose. Make sure that the spark plug
lead does not contact the VVA (variable valve
actuator) solenoid or water pump inlet hose.
B. Insert the projection on the rear wheel sensor
coupler into the hole in the fuel tank overflow tray.
C. Fasten the coolant temperature sensor lead to the
radiator inlet hose with the plastic band. Point the
end of the plastic band outward.
2-40
CABLE ROUTING