Adjusting The Front Wheel Static Balance; Installing The Front Wheel (Front Brake Disc) - Yamaha MBK X-MAX 300 2017 Service Manual

b. Install the spacer.
c. Install the new wheel bearing (left side).
TIP
Place a suitable washer "1" between the socket
"2" and the bearing so that both the inner race
"3" and outer race "4" are pressed at the same
time, and then press the bearing until the inner
race makes contact with the spacer "5".
EAS30152
ADJUSTING THE FRONT WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the front
wheel static balance should be adjusted.
• Adjust the front wheel static balance with the
brake disc installed.
1. Remove:
• Balancing weight(s)
2. Find:
• Front wheel's heavy spot
3. Adjust:
• Front wheel static balance
4. Check:
• Front wheel static balance
EAS30154
INSTALLING THE FRONT WHEEL (FRONT
BRAKE DISC)
1. Install:
• Front brake disc "1"
• Front wheel sensor rotor "2"
Front brake disc bolt
23 N·m (2.3 kgf·m, 17 lb·ft)
LOCTITE®
Front wheel sensor rotor bolt
8 N·m (0.8 kgf·m, 5.9 lb·ft)
LOCTITE®
ECA21011
NOTICE
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
• Replace the brake disc bolts and wheel
sensor rotor bolts with new ones.
TIP
• Install the brake disc with its chamfered side
"a" facing inward.
• Install the front wheel sensor rotor with the
stamped mark "b" facing away from the wheel.
• Tighten the bolts in stages.
1
b
2. Check:
• Front brake disc
Refer to "CHECKING THE FRONT BRAKE
DISC" on page 4-44.
3. Lubricate:
• Front wheel axle
• Front wheel axle nut
Recommended lubricant
Lithium-soap-based grease
4-31
FRONT WHEEL
a
2