Installing The Front Wheel (Disc Brake) - Yamaha TRACER MT09TRA Service Manual

c. If the heavy spot does not stay in that posi-
tion, install a heavier weight.
d. Repeat steps (b) and (c) until the front wheel
is balanced.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
4. Check:
• Front wheel static balance
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Turn the front wheel and make sure it stays at
each position shown.
b. If the front wheel does not remain stationary
at all of the positions, rebalance it.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS30154
INSTALLING THE FRONT WHEEL (DISC
BRAKE)
1. Install:
• Front brake discs
Front brake disc bolt
18 Nm (1.8 m·kgf, 13 ft·lbf)
LOCTITE®
ECA19150
NOTICE
Replace the brake disc bolts with new ones.
TIP
Tighten the brake disc bolts in stages and in a
crisscross pattern.
2. Check:
• Front brake discs
Refer to "CHECKING THE FRONT BRAKE
DISCS" on page 4-40.
3. Lubricate:
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
4. Install:
• Collar
• Front wheel sensor housing
• Front wheel
• Front wheel axle
TIP
Align the slot "a" in the sensor housing with the
projection "b" of the front fork before assembly.
a
b
5. Tighten:
• Front wheel axle
• Front wheel axle pinch bolt
Front wheel axle
65 Nm (6.5 m·kgf, 47 ft·lbf)
Front wheel axle pinch bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
ECA19760
NOTICE
Before tightening the wheel axle, push down
hard on the handlebars several times and
check if the front fork rebounds smoothly.
4-25
FRONT WHEEL