Yamaha N MAX GPD150-A 2015 Service Manual page 224

REAR SHOCK ABSORBER ASSEMBLIES AND SWINGARM
• Spacer "5"
(to the swingarm "6")
Bearing retaining plate bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
• Install the oil seal until it is flush with the sur-
face "a" of the swingarm.
• Install the oil seal until it is flush with the sur-
face "b" of the bearing retaining plate.
• Install the bearing retaining plate with the
punch mark "c" facing outward.
• While holding the rear brake hose guide so that
the portion "d" of the guide contacts the bearing
retaining plate.
1
New
2
LS
2 New
a
d
3. Install:
• Swingarm assembly "1"
• Rear wheel axle nut "2"
(temporarily tighten)
• Swingarm mounting bolt (upper side) "3"
(temporarily tighten)
6
3
New
2
5
LS
2 New
b
3
c
4
• Swingarm mounting bolt (lower side) "4"
(temporarily tighten)
4. Tighten:
• Rear wheel axle nut "2"
• Swingarm mounting bolt (upper side) "3"
• Swingarm mounting bolt (lower side) "4"
Rear wheel axle nut
125 Nm (12.5 m·kgf, 90 ft·lbf)
Swingarm mounting bolt
57 Nm (5.7 m·kgf, 41 ft·lbf)
TIP
Tighten the rear wheel axle nut "2", then the
swingarm mounting bolts "3", "4".
2
5. Install:
• Rear shock absorber assemblies
Rear shock absorber assembly
nut
16 Nm (1.6 m·kgf, 12 ft·lbf)
Rear shock absorber assembly
bolt
21 Nm (2.1 m·kgf, 15 ft·lbf)
TIP
Tighten the rear shock absorber assembly nuts
and bolts temporarily, and then tighten them to
specification.
6. Measure:
TIP
Measure the distance "a" only if the wheel bear-
ings, wheel sensor rotor, or both were replaced.
• Distance "a"
(between the wheel sensor rotor "1" and
swingarm "2" (edge of the wheel sensor in-
stallation hole "b"))
Out of specification → Reinstall the bearing
or replace the wheel sensor rotor.
4-91
1
3
4