Yamaha N MAX GPD150-A 2015 Service Manual page 129

3. Check:
• Throttle grip free play "a"
Out of specification → Adjust.
Throttle grip free play
3.0–5.0 mm (0.12–0.20 in)
4. Adjust:
• Throttle grip free play
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Slide back the rubber cover "1".
b. Loosen the locknut "2".
c. Turn the adjusting nut "3" in direction "a" or "b"
until the specified throttle grip free play is ob-
tained.
Direction "a"
Throttle grip free play is increased.
Direction "b"
Throttle grip free play is decreased.
d. Tighten the locknut.
Throttle cable adjusting locknut
3.8 Nm (0.38 m·kgf, 2.8 ft·lbf)
e. Slide the rubber cover its original position.
TIP
Make sure that the adjusting nut is covered com-
pletely by the rubber cover.
a
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
PERIODIC MAINTENANCE
EWA17990
WARNING
After adjusting the throttle grip free play,
start the engine and turn the handlebars to
the right and to the left to ensure that this
does not cause the engine idling speed to
change.
▲ ▲▲▲ ▲ ▲▲▲ ▲
EAS30663
CHECKING THE SWITCHES, LIGHTS AND
SIGNALS
1. Check that all switches operate and that all
lights come on.
Refer to "INSTRUMENT AND CONTROL
FUNCTIONS" in Owner's manual.
Faulty → Refer to "CHECKING THE
SWITCHES" on page 8-95 and "CHECKING
THE BULBS AND BULB SOCKETS" on
page 8-98.
▼▼▼
EAS30664
ADJUSTING THE HEADLIGHT BEAM
1. Adjust:
• Headlight beam (vertically)
▼ ▼▼▼ ▼ ▼▼▼ ▼
a. Turn the adjusting bolt "1" in direction "a" or
"b".
Direction "a"
Headlight beam is raised.
Direction "b"
Headlight beam is lowered.
▲ ▲▲▲ ▲ ▲▲▲ ▲
3-24
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
▲ ▲▲▲ ▲ ▲▲▲
▼ ▼▼▼ ▼ ▼▼▼
1
b
▲ ▲▲▲ ▲ ▲▲▲