Mid-Point Voltage (Vmid) (Motor 0); Minimum Output Frequency (Fmin) (Motor 0); Minimum Output Voltage (Vmin) (Motor 0); Output Frequency Upper Limit - Delta Electronics AC Motor Drive VFD-E User Manual

01.04

Mid-Point Voltage (Vmid) (Motor 0)

Settings 115V/230V series 0.1 to 255.0V
This parameter sets the Mid-Point Voltage of any V/f curve. With this setting, the V/f ratio
between Minimum Frequency and Mid-Point Frequency can be determined. This parameter
must be equal to or greater than Minimum Output Voltage (Pr.01.06) and equal to or less than
Maximum Output Voltage (Pr.01.02).
This setting should be greater than Pr.01.06.
01.05

Minimum Output Frequency (Fmin) (Motor 0)

Settings
This parameter sets the Minimum Output Frequency of the AC motor drive. This parameter
must be equal to or less than Mid-Point Frequency (Pr.01.03).
The settings of 01.03, 01.04, and 01.06 are invalid in Vector Control mode.
01.06

Minimum Output Voltage (Vmin) (Motor 0)

Settings
This parameter sets the Minimum Output Voltage of the AC motor drive. This parameter must
be equal to or less than Mid-Point Voltage (Pr.01.04).
The settings of Pr.01.01 to Pr.01.06 have to meet the condition of Pr.01.02 ≥ Pr.01.04 ≥
Pr.01.06 and Pr.01.01 ≥ Pr.01.03 ≥ Pr.01.05.
In vector control mode (Pr.00.10 is set to 1), Pr.01.03, Pr.01.04 and Pr.01.06 are disabled.
01.07

Output Frequency Upper Limit

Settings
This parameter must be equal to or greater than the Output Frequency Lower Limit (Pr.01.08).
The Maximum Output Frequency (Pr.01.00) is regarded as 100%.
Output Frequency Upper Limit value = (Pr.01.00 * Pr.01.07)/100.
Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
460V series 0.1 to 510.0V
0.10 to 600.0Hz
115V/230V series 0.1 to 255.0V
460V series
0.1 to 120.0%
0.1 to 510.0V
Chapter 4 Parameters|
Factory Setting: 10.0
Factory Setting: 20.0
Factory Setting: 1.50
Factory Setting: 10.0
Factory Setting: 20.0
Factory Setting: 110.0
Unit: 0.1
Unit: 0.01
Unit: 0.1
Unit: 0.1
4-43