Multi-Function Input/Output Parameters For Extension Card; Multi-Function Output Terminal Mo7/Ra7 - Delta Electronics AC Motor Drive VFD-E User Manual

Chapter 4 Parameters|
Group 11: Multi-function Input/Output Parameters for Extension Card
Make sure that the extension card is installed on the AC motor drive correctly before using group 11
parameters. See Appendix B for details.
11.00
Multi-function Output Terminal MO2/RA2
11.01
Multi-function Output Terminal MO3/RA3
11.02
Multi-function Output Terminal MO4/RA4
11.03
Multi-function Output Terminal MO5/RA5
11.04
Multi-function Output Terminal MO6/RA6
11.05

Multi-function Output Terminal MO7/RA7

Settings
Settings Function
No Function
0
1 AC Drive Operational
Master Frequency
2
Attained
3 Zero Speed
4 Over-Torque Detection
Baseblock (B.B.)
5
Indication
6 Low-Voltage Indication
Operation Mode
7
Indication
8 Fault Indication
4-138
0 to 21
Active when the drive is ready or RUN command is "ON".
Active when the AC motor drive reaches the output
frequency setting.
Active when Command Frequency is lower than the
Minimum Output Frequency.
Active as long as over-torque is detected. (Refer to Pr.06.03
~ Pr.06.05)
Active when the output of the AC motor drive is shut off
during baseblock. Base block can be forced by Multi-
function input (setting 09).
Active when low voltage (Lv) is detected.
Active when operation command is controlled by external
terminal.
Active when a fault occurs (oc, ov, oH, oL, oL1, EF, cF3,
HPF, ocA, ocd, ocn, GFF).
Description
Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
Factory Setting: 0